|
Hardware |
|
WAN |
1 x 10/100Mbps RJ-45 port |
|
LAN |
1 x 10/100Mbps RJ-45 port |
|
Voice |
4 x RJ-11 connection (2 x FXS, 2 x FXO) |
|
Protocols and Standard |
|
Data Networking |
IPv4 (RFC 791) and IPv6 |
|
IPv6 auto configuration (RFC 4862) |
|
IPv6 only, IPv4 only or dual stack |
|
MAC address (IEEE 802.3) |
|
MAC clone setting |
|
Vendor Class ID |
|
IP / ICMP / ARP / RARP / SNTP |
|
Static IP |
|
DHCP Client (RFC 2131), WAN port |
|
DHCP Server, LAN port |
|
NAT Server (RFC 1631) |
|
PPPoE Client / DNS Client / TFTP Client |
|
DDNS (Planet DDNS, Easy DDNS, DynDNS) |
|
Firewall |
|
URL / IP / MAC / Port Filter |
|
Application Program Filter |
|
Port Forwarding (TCP, UDP or both) |
|
Bandwidth control (download and upload), maximum bandwidth priority setting |
|
UPnP Server at LAN port |
|
Behind NAT, use DMZ for NAT traversal |
|
SNTP with time zone and Daylight Saving |
|
TCP/UDP (RFC 793/768), RTP/RTCP (RFC 1889/1890), IPV4 ICMP (RFC 792) |
|
VoIP VLAN Support 802.1Q, 802.1P |
|
VLAN ID Range: 2 to 4094 |
|
VLAN Priority: 0 to 7 (Highest Priority) |
|
QoS: DiffServ (RFC 2475), TOS (RFC 791, 1394) |
|
Voice Gateway |
RFC 3261 compliance |
|
Supports up to 4 SIP Trunks to Register |
|
SIP UDP Protocol |
|
Supports SIP compact Form |
|
Supports SIP HOLD Type: Send Only, 0.0.0.0 or inactive |
|
SIP Session Timer (RFC 400FS8) |
|
SIP Session Refresher: UAC or UAS |
|
SIP Encryption |
|
MD5 Digest Authentication (RFC 2069 / RFC 2617) |
|
Reliability of provision response PRACK (RFC 3262) |
|
Early/Delay Media support |
|
Offer/Answer (RFC 3264) |
|
Message Waiting Indication (RFC 3842) |
|
Event Notification (RFC 3265) |
|
REFER (RFC 3515) |
|
Supports Outbound Proxy |
|
Supports Primary and Backup SIP Server |
|
Supports STUN NAT Traversal |
|
Supports “rport” parameter (RFC 3581) |
|
Configure SIP local Port |
|
SIP QoS Type: DiffServe or QoS |
|
Accept Proxy Only : Yes or No |
|
Audio Codec |
G.711 A-law/μ-law, G.729A, G.723.1 (6.3K, 5.3K) |
|
Select voice codec priority : Local or Remote |
|
Voice Payload size (ms) configuration |
|
Silence Suppression |
|
VAD/CNG |
|
LEC : Line Echo Canceller |
|
Max Echo Tail Length (G.168): 32, 64 and 128ms |
|
Packet Loss Compensation |
|
Automatic Gain Control |
|
In-band/out of band DTMF (RFC4733, RFC2833 / SIP INFO) |
|
Adaptive/Configurable Jitter Buffer |
|
G.168 Acoustic Echo Cancellation |
|
Configure RTP basic Port |
|
RTP QoS Type : DiffServ or TOS |
|
Phone Book (50 records) for peer to peer calls |
|
Dialing Plan with drop, replace, Insert dialing digits |
|
Selects first digit and inter digit timeout duration (Sec) |
|
Selectable Call Progress Tone |
|
Supports Specified Line Calling |
|
Functions |
|
Call Functions |
Supports Peer to Peer dialing |
|
2-line FXO connects to PSTN Line |
|
2-line FXS connects to analog phone set or PABX |
|
Caller ID recognition DTMF (before/after 1st ring) and FSK (before 1st ring), ETSI and Bellcore |
|
DTMF Caller ID start and stop BIT configurable |
|
Current Drop Detection to release FXO port |
|
Disconnect tone recognition to release FXO port |
|
Tone Generation: Ring Back, Dial, Busy, call waiting, ROH, Warning, Holding, Stutter dial tone and disconnect tone |
|
Configure Tone Frequency, Cadence, Level and Cycle |
|
Select Tone specification by Country name List |
|
Global Country Based Tone Specification |
|
NAT Traversal support STUN, UPNP and Behind NAT |
|
Out-Band DTMF with RFC 2833 and SIP Info |
|
RFC 2833 Payload type: 101 or 96 |
|
DTMF send out ON and OFF Time configure |
|
DTMF incoming recognition Minimum ON and OFF time |
|
DTMF Relay Volume configuration |
|
T.38 FAX Volume configuration |
|
Flash Time transmit via SIP Info (Enable or Disable) |
|
Message Waiting Indication (Stutter Tone Notice) |
|
Blocks Anonymous Call |
|
Call Hold, Call Transfer |
|
FXO/FXS Line Configuration |
Activates or deactivates : Line ID, Line Phone number |
|
Polarity Reversal detection or generation for call establish and Billing |
|
HOT Line to desired phone number |
|
Plays voice file to incoming call |
|
Repeats playing voice file counts |
|
Self-recorded voice files to upload |
|
Generates FLASH TIME to PSTN network |
|
T.38 or FAX Relay Type |
|
Incoming and outgoing dB value configurable |
|
Dialing Answer Delay time to establish call path |
|
Answers PSTN incoming call after how many ring cycles |
|
Caller ID detection mode by Country selection |
|
VoIP dial to FXO/PSTN Line: 1 stage dialing and 2 stage dialing |
|
Outgoing SIP Caller ID Selection |
|
Supports 4 SIP Trunk |
|
Accepts desired SIP Proxy incoming calls Only |
|
Flexible Routing Plan |
Prefix Match and Length |
|
Priority Ring |
|
Cyclic Ring |
|
Simultaneous Ring |
|
Programmable Hunting Cycle |
|
Backup Routes with Digit Manipulation |
|
Default Routes |
|
Flexible Dial Plans |
Retrieves transfer call from 3rd party by dial code (default: *#) |
|
Inter digit time out setting |
|
First digit dial out delay time setting |
|
End of dial keypad number |
|
Dial Rule : Match dial prefix and maximum digits length (1-15) |
|
Phone Book can be exported or imported |
|
FXS Analog 2-wire interface |
Flash Time Detection: range from 80 to 800 ms |
|
ON-HOOK Voltage -48Vdc |
|
Configure Ring Cadence, Frequency and Voltage |
|
Supports Polarity reversal for Billing |
|
Service Up to 1 Kilo-meter distance to analog telephone set |
|
Generate Current Drop Time (Open Loop Disconnect time) |
|
FXO Analog 2-wire interface |
Incoming Ring frequency recognition range: 10 to 70 Hz |
|
Incoming Ring ON time recognition range: 0 to 8000ms |
|
Incoming Ring OFF time recognition range: 0 to 8000ms |
|
Incoming Ring Level recognition range: 10 to 95Vrms |
|
Flash Time Detection: range from 80 to 800 ms |
|
Configure Ring Cadence, Frequency and Voltage |
|
Management |
Administrative Telnet CLI and HTTP, HTTPS |
|
HTTP provision through MAC address |
|
Multilingual Web User Interface |
|
3 Levels of User Access Right with Password protection with different Web Language (Administrator, Supervisor and User) |
|
HTTP/HTTPS Service Access limitation from WAN port |
|
Configure Service ports at HTTP, HTTPS and telnet Services |
|
Phone Debug Module: Device Control, Call Control, DB, Verbose |
|
SIP Debug Module: Register, Call, SIP Message, Others |
|
SNTP Debug Module |
|
Device Debug Module |
|
DSP Debug |
|
Provides System Status Logs |
|
Connect to external SYSLOG Server |
|
Status display: Network, Line, SIP Trunk status |
|
Diagnostics (debug through Syslog Event Notice) |
|
Debug in real time by Telnet |
|
Auto Provision via HTTP Server |
|
SNMP v2 / Trap |
|
Configuration Backup/Restore |
|
Dual Firmware Image Backup |
|
Reset to factory Default |
|
Environments |
|
Power Requirements |
12V DC, 2A |
|
Operating Temperature |
0 ~ 45 degrees C |
|
Operating Humidity |
10~90% relative humidity, non-condensing |
|
Weight |
500 g |
|
Dimensions (W x D x H) |
175 x 32 x 126 mm |
|
Emission |
CE, FCC, RoHS |
|
Connectors |
Two 10/100Base-TX RJ-45 Ethernet ports |
|
Four RJ-11 ports |
|
DC power jack |
